Welcome to our websites!

How to choose insulating glass production equipment

www.cbsglassmachine.com

Many people will see that the price of insulating glass production equipment is relatively low, the operation steps in the research and development are relatively simple, the cost is relatively low, and the utilization rate is relatively high, and the effect it can play is also very ideal. We can use different types of core technologies and achieve good results in the R & D process, so that everyone can have a lot of help in the selection process.

After the glass information is given, such as ordinary flat glass or tempered glass, the fracture strength of the original glass sheet can be determined according to the glass strength design theory. Because the glass produced by the insulating glass machine is composed of two pieces (or more than two pieces) of glass, and the sealing around the furnace forms a sealed air layer. When one side of the insulating glass is under the action of load, the stressed side of the glass deforms and contracts the gas in the insulating layer, and the gas pressure increases, transmitting some loads to the other side of the glass. Therefore, in the state of gas sealing, the insulating glass is two layers Two pieces of glass bear the load together, and two pieces of glass deform together. Insulating glass is a two-layer or multi-layer flat glass, which is made of aluminum frame filled with desiccant and bonded with butyl basic wave and polysulfide glue.

To improve the production environment of insulating glass, insulating glass must be produced in an environment free of dust, solvent pollution and suitable temperature. The dust pollution in the production workshop will have a great negative impact on the bonding of each component of insulating glass sealing system.

Before cutting the glass of different batches from different manufacturers, we should first check whether there is color difference, and separate the glass with larger color difference for different projects or different building facades. The glass cutting scale should be strictly implemented according to the requirements of the drawing. The operator should pay attention to the appearance of the glass, and there should be no obvious defects such as scratches and bubbles. Selection of aluminum bar and angle: the thickness of aluminum bar should be 0. 30mm~0。 The thickness should be uniform between 35mm and 35mm, and the air holes should be evenly distributed. Aluminum strip must be anodized or decontaminated. Good quality and high-level products must be selected to improve the utilization rate of aluminum strip. The size of the inserted angle should be selected and the appearance should be cleaned.


Post time: Mar-31-2021